How To Hang A Rug With Fringe On The Wall

First mark where you want the rug.

How to hang a rug with fringe on the wall.

A heavy cotton casing may be sewn onto the back of the rug again this should be hand sewn if hanging a handmade or antique rug to form a tube through which the curtain rod may be inserted. This method allows you to hang a fringed rug on the wall without damaging it. Attach the tape to the back of the rug in the same way as for a smaller rug. Sew muslin to the top of the rug.

The second method of hanging a rug should be used for large and heavy weight rugs. Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug. Now add your contrasting fringe. This should be attached close to the top of the rug.

Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug. Knot a decorative c. Hanging fringed rug on wall hanging fringed rug on wall. For extra support hammer nails into the corners.

Repeat until the entire rug is covered in fringe. To hang a round rug on the wall you would use push pins or command strips. Insert a suitable rod. Then pin the bottom.

Lift the rug and press it into the strap to attach it. Attach rod support the brackets to the wall aligned with the gaps in the. This will serve as casing for your rod when hanging the rug. First cut the tape into 12 inch sections and attach the sections to the rug 1 2 inch apart.

Since you ve already measured your carpet tacks to the length of your rug you ll want to place the strip where the top of the rug will sit on your wall. To protect your rug from the wood and nails paint or seal the rug strip and let it dry completely. Hot glue a strip of the cotton fringe right along the long bottom edge of your rug. Sew fabric to the top of the rug forming a tube.

Using a level to ensure the strip is entirely straight attach the piece to the wall using nails or screws. Pass a bar through the strip and hang the rug. Next stretch it out left and right and place additional push pins there. The second method of hanging an area rug on the wall involves the use of a curtain rod.

This method allows you to hang a fringed rug on the wall without damaging it. Cut a few small strips and lay them on top to decide where you want them. These gaps permit the use of additional brackets and prevent sagging. Hot glue another strip about 1 2 to 1 depending on how dense you want the fringe to be above the last.

Insert rod into the tube of fabric on the rug and hang the rod onto the wall. Hanging fringed rug on wall. Line up the carpet tack strips where you ll want to hang the rug and gently hammer the nails into the wall. Cut a piece of fabric the same width of your rug large enough to be able to form a tube that will snuggly fit the width of your rod.