How To Fit A Toilet Pan To The Floor

It s simple the watertight seal between the toilet bowl and wax ring will eventually fail.

How to fit a toilet pan to the floor.

To fit a toilet with l shaped clamps simply. I can remember when i started my apprenticeship as a plumber every toilet pan was secured to the floor with a sand and cement mix mortar. Make sure the seat can remain in an upright position. Diyers often set the toilet and then apply a tiny bead of caulk along the outside edge.

To install a new toilet first turn off the water supply and remove the old toilet. How to attach them safely to the. Screws are then fixed into these brackets from the outside. This video covers how to install a toilet.

Fit a new seal around the drain hole in the floor and make sure it s tight. Turn on the water and check for leaks. The first step in removing an old toilet is to turn off the water at the shutoff valve located either on the wall or floor behind or beside the toilet. Then lift the toilet onto the floor bolts and jiggle it a bit to seal the drainage hole.

Toilets should be caulked to the floor to prevent side to side movement that can break the wax seal and to prevent splashes or overflows from puddling under the toilet and rotting the floor. Attach the water inlet pipe taking care not to overtighten. Follow the instructions for your specific toilet for further help securing your toilet to the floor. Steve used an oatey 4 replacement toilet flange for cast iron pipes.

Level the toilet base then tighten the bolts and cap them. We would place the toilet pan on the floor and mark out the foot print with a pencil and the remove it again the next step would be to cut a hole in the floor under the pan for a key this would create a lock between the pan and the floor. Includes how to remove a toilet bowl or pan and cistern and install the new ones. Flush the toilet to drain all the water from the tank and toilet bowl.

To fit the toilet seat check out our toilet seat fitting guide. Connect the pan to the waste pipe using the pan connector. If the toilet flange sits below the finished floor the toilet will leak. That doesn t always provide a good enough bond to the floor.